Integra TUN-3.7 - Manual (Page 8)

8
Getting to Know the TUN-3.7
For detailed information, refer to the pages in parentheses.
A Standby/On button (19)
Sets the TUN-3.7 to On or Standby.
B Standby indicator (19)
Lights up when the TUN-3.7 is on Standby.
C Category [ ]/[ ] buttons (23, 26)
Used to select categories for satellite radio. With
HD Radio stations, they’re used to select multicast
channels.
D Preset [ ]/[ ] buttons (27)
Used to select radio presets.
E Dimmer button (9)
Adjusts the display brightness.
F Display button (24, 26)
Used to view various information on the display.
G Band button (19, 22)
Used to select radio bands, AM, FM, and so on. The
bands available depends on the type of tuner board
installed.
H Tuning/CH [ ]/[ ] buttons (19, 23)
With AM and FM, these buttons are used for tuning.
With XM Radio, they’re used to select stations.
I Auto Scan button (26, 27)
Starts the Auto Scan function, which selects and
outputs each radio preset in turn for 5 seconds.
J Remote control sensor (7)
Receives control signals from the remote controller.
K Display
See the next page.
L Memory button (27)
Used to store and delete radio presets.
M Tuning Mode button (19, 23, 27)
With AM and FM, this button selects the Auto or
Manual tuning mode. With XM Radio, it selects the
search modes.
* XM Radio/HD Radio reception requires C-HDXM
tuner board.
Front Panel
A
9 K J L M
B C 4 5 6 7 8