Inova OnTimeTM - Manual (Page 9)

Inova OnTime Digital Clock Owner's Manual
All claims based on information publicly available at time of printing. All other product or service names mentioned in this document may be
trademarks of the companies with which they are associated. © 2007 Inova Solutions. | All rights reserved. 6.12.2007 | page 4
Section 4: Unpacking and Installation
The OnTime Digital Clock arrives fully assembled in a single package. Inspect the clock and
report any damage to Inova Solutions, Inc.
Once you have removed and inspected the clock, you have several mounting options to
consider. The procedures for surface mounting, pendant mounting, and cantilever
mounting are included on the following pages.
Surface Mounting
The following is a recommended procedure for surface mounting. No mounting kit is
required.
1. Determine the clock mounting location.
2. Mark two points 10” (25.4 cm) apart, level, and centered on the data cable outlet.
3. Insert two flat-head fasteners suitable for the wall surface at the marked points and tighten.
4. Withdraw the fasteners until there is a 1/16” (.16cm) gap between the mounting surface and
the back of the fastener head.
5. Insert the data cable into the jack located at the back of the OnTime Digital Clock.
6. Position the keyhole slots located on the rear of the clock over the fastener heads.
7. Pull the clock slightly downward until the unit is seated.