IntraServer Technology 5232E User Manual
Page 23
23
NetWare
The Novell Netware driver, DC21x4 is used with both Netware 3.1x and Netware 4.x
servers.
Netware 3.x Server Driver
1.
Prepare the hard drives of your server according to the instructions in your Netware
3.1x documentation.
2.
While the server is down, insert the IntraServer Setup diskette into your server’s A
drive.
3.
Copy the contents of a:\netware\311 or a:\netware\312 to the disk from which you
boot Netware 3.1x
4.
Type SERVER at the DOS prompt press Enter to boot the Netware 3.1x Server.
5.
Type LOAD INSTALL at the server console prompt and press Enter
6.
Select System Options
7.
Select Edit AUTOEXEC.NCF File
8.
Edit the autoexec.ncf file. You must load the device driver once for each port used.
NetWare 4.x and 4.11
The Novell Netware driver DC21X4 is used with Netware 4.11 servers.
1.
Type LOAD INSTALL at the server console prompt and press Enter.
2.
On the Installation Options menu, select Driver options (load/unload disk and
network drivers).
3.
On the Driver Options menu, select Configure Network Drivers. The system displays
the installed network drivers, and the Additional Driver Actions menu
4.
Select a driver and press Enter. If the desired IntraServer driver is not on the list,
proceed to Step 5.
5.
Insert the IntraServer Setup diskette into drive A and press<INS> to install the
unlisted driver.
6.
Press Enter. The system scans path a:\ for uninstalled drivers.
7.
Press Enter to install the NetWare 4.x driver in drive A.
8.
Select yes to copy the driver DC21X4