IntraServer Technology 5232E - Manual (Page 29)

29
For example, to set the media type and speed to FAST Twisted Pair, enter the
command:
>>>set ewa0_mode FAST
If you will be remote booting via the Ethernet, you must also set the boot protocol
to match that of the boot node. Typically OpenVMS uses MOP protocol and UNIX
uses BOOTP.
For example to set a port to MOP (VMS) use:
>>>set ewa0_protocol MOP
Note: Port 0 will be the lowest controller letter found by the SRM console, “A” if there are
no other Ethernet ports in the system. If there is an onboard Ethernet controller, it will be
assigned port letter “A” and the ports on your ITI-5232 will be assigned “B,C,D and E” for
ports “0,1,2 and 3” respectively.