IntraServer Technology 5232E - Manual (Page 26)

26
Digital UNIX
Drivers for the ITI-5232E are on the Digital UNIX distribution kit beginning with
Version 4.0D. Digital UNIX will identify the ITI-5232E as four 21140 based Ethernet
controllers.
Once the hardware is installed in your system, boot the system using genvmunix, in the
following manner:
>>>boot –file genvmunix
This will cause Digital UNIX to scan all hardware devices in the system, and identify the
ITI-5232E . Four 21140 based Ethernet adapters will be identified.
Create a new kernel with support for the four Ethernet ports, identified in genvmunix by
using the doconfig command.
# doconfig
When doconfig completes backup your existing kernel as follows:
# cp /vmunix /vmunix.sav
Then copy the new kernel created by doconfig, to /vmunix, and shutdown and reboot with
your new kernel.
If you are unfamiliar with doconfig, refer to your Digital UNIX documentation for
additional information.
Note: Digital UNIX relies on the settings for media type and speed set by the SRM console.
See Appendix A for more information.