Intel ATX 0.9 - Manual (Page 22)

Intel ATX Power Supply Design Guide
Version 0.9
Page 22
53 REF
WIRE HARNESS
16 REF
150 REF
20.0
(2X)
4.0X6
94.0
11.0 x 5.0 cutouts (4X);
min 6.0 clearance under
cutout from inside top cover.
See Note 5.
Area on top surface
inside dotted lines should
have 60% minimum open
area for proper venting.
Eight rectangular holes
are for air duct mounting
to direct airflow across
processor heatsink.
146.0
140 REF
5.0
5.0
86 REF
80.0
45.0
8.0 114.0
138.0
3. Tolerances:
X +/- 1
X.X +/- 0.5
4. If a wire grill is required
for acoustics or thermals,
the grill and screws must
be flush mounted.
5. Bottom side (not pictured)
may be user-accessible in
final system installation.
Cover openings as
necessary to prevent
access to non-SELV
circuitry and to meet product
safety requirements.
No. 6-32 UNC-2B THREADED HOLE (4X)
Notes; unless otherwise specified:
1. Dimensions are in mm.
2. Drawing is not to scale.
64.0
16.0
6.0 (2X)
114.0
See Note 4.
9.0 x 3.2 cutouts (4X);
min 5.0 clearance under
cutout from inside top cover.
74.0
6.0
Figure 3: Power Supply Dimensions for Chassis in Which the P/S Cools the Processor