Icom MR-1000TTM - Manual (Page 12)

BASIC OPERATION
4
8
■ Checking the installation
Before turning the power ON, be sure all the connec-
tions are complete. The checklist at right may be help-
ful for necessary confirmation. D Checklist
q The 4 bolts securing the scanner unit must be firmly
tightened.
w Cabling must be securely attached to a mast or
mounting material, and must not interfere with the
rigging.
e Be sure waterproofing procedures are completed
on the system cable.
r The power connections to the battery must be of the
correct polarity.
t Be sure that the plugs at the rear of the display unit
have been connected correctly and securely.
(See p. 24 for details.)
CAUTION: Connect the scanner unit before turning the
power ON. Otherwise the magnetron inside the scanner
unit might be damaged.
■ Turning power ON/OFF
q Push [POWER]/[ ] to turn the power ON.
• The initial screen appears and warming up time is
counted down on the screen.
• The magnetron inside the scanner unit warms up for 90 sec.
• [POWER]/
[ ] does not function for 2 sec. after
the power is turned OFF.
w When the countdown is completed, the Standby
screen appears.
e Push [TX]/[ ] to start scanning and select
the Plan Position Indicator (PPI) screen.
• Targets and heading marker appear.
• The screen appears approx. 2 sec. after turning the
power on, when ‘AUTO’ is selected in the “TUNE” of the
VIDEO menu.
r Push [POWER]/[ ] to turn the power OFF.
1 (0.25) T.V E C T 6 M
0.0 0 0 N M NM C U R S
S O G 1 7 . 7 K T H U P
0 0 0 . 0 ˚ T
H D G 2 5 3 . 4 ˚ T
E B L 1
E B L 2
MOB V R M 1
V R M 2
C U R S 3 4 ˚ 3 7 . 7 2 N 1 3 5 ˚ 3 4 .4 2 E
S T B Y
IR
COMPASS GPS
1 (0.25) T.V E C T 6 M
0.00 0 N M NM C U R S
S O G 1 7 . 7 K T H U P
0 0 0 . 0 ˚ T
H D G 2 5 3 . 4 ˚ T
E B L 1
E B L 2
MOB V R M 1
V R M 2
C U R S 3 4 ˚ 3 7 . 7 2 N 1 3 5 ˚ 3 4 .4 2 E
IR
COMPASS GPS
0.45
R E V *.*
ROM OK
RAM OK
MR-1000R2_T2.qxd 04.2.24 10:22 Page 8