Icom I706MKTMG - Manual (Page 42)

39
5
MEMORY AND SCAN OPERATION
■ Memory channels
The transceiver has 105 memory channels (plus 2 call
channels). Memory mode is useful for quickly chang-
ing to often-used frequencies.
All 105 memory channels are tuneable which means
the programmed frequency can be tuned temporarily
with the main dial, etc., in memory mode.
➀
Select M2 functions.
• Push [DISPLAY] 1 or 2 times to select M.
• Push [MENU] one or more times to select M2.
➁
Push [ (F-3) V/M] to select memory mode.
➂
Rotate [M-CH] to select the desired memory chan-
nel.
• All memory channels including blank channels can be
selected.
• [UP]/[DN] on the microphone changes the frequency.
➃
To return to VFO mode, push [ (F-3) V/M] again.
Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels.
➀
Push [ (F-3) V/M] in the M2 display to select mem-
ory mode.
➁
Rotate [M-CH] to select a memory channel to be
cleared.
➂
Push [MCL (F-2) ] for 2 sec. to clear the contents.
• The programmed frequency and operating mode disap-
pear and “}” appears.
➃
To return to VFO mode, push [ (F-3) V/M] again.
■ Memory channel selection
■ Memory clearing
Note: During split frequency operation, programmed
memory contents can be called up to the SUB readout
(dot matrix portion of the display).
CW
CH
VFO A
[EXAMPLE]: Selecting memory channel 17.
V/M
F-3 USB
CH MEMO
SPLIT
CH MEMO
USB
M-CH SHIFT
MCL
F-2
SPLIT
Push for
2 sec.
CH MEMO
USB
CH MEMO
BLANK
MEMORY
CHANNEL
MEMORY
CHANNEL
NUMBER
CAPABILITY
TRANSFER
TO VFO
OVER-
WRITING
CLEAR
Regular
(split memory)
1–99
Independent transmit and receive
frequencies and one mode in each
memory channel.
In addition, tone frequencies (or
1750 Hz tone burst) can also be
stored for repeater use.
Yes Yes Yes
Scan edges
1A–3B
(3 pair)
One frequency and one mode in
each memory channel as scan
edges for programmed scan.
Yes Yes No
Call channel
(split memory)
C1 (144 MHz)
C2 (430 MHz)
Same as regular, but only 144/430
MHz band can be programmed.
Yes Yes No