Invacare Auriga10 - Manual (Page 33)

33
7 Adjustment Options
7.1 Adjusting the angle of the backrest
The backrest is held in place by a metal plate on each side. Each plate has 4 holes that are used to
set the backrest to different angles. This is done by selecting different combinations of holes.
Requirements:
•
Allen key, 4 mm
•
Spanner, 10 mm
•
Remove the screws on both sides of the seat that hold the
backrest (1), using the spanner and Allen key.
•
Adjust the backrest to the desired angle.
•
Reposition the screws and tighten.