Invacare 3600XL - Manual (Page 12)

SECTION 1—GENERAL GUIDELINES
Side Entry Whirlpool Tub 12 Part No 1118387
Maintenance and Inspection
Ꮨ DANGER
ELECTRICAL SHOCK HAZARD. All disassembly and maintenance of the tub
MUST be done by a qualified technician, certified electrician or plumber.
Disconnect electrical supply or turn off circuit breaker before performing any
maintenance to the tub.
If any part of the system is not functioning properly, DO NOT use the system. Have the
system serviced to correct the problem.
The system MUST be maintained on a regular basis to ensure it is functioning properly.
Disinfecting
Disinfect the tub after initial set up and ALWAYS disinfect the tub after each use to avoid
resident infection and contamination of the tub.
DO NOT disinfect the tub when it is occupied otherwise injury may occur.
ALWAYS wear gloves, protective apron, and face shield protection when disinfecting or
cleaning your tub.
ALWAYS handle disinfectants, cleaning compounds, and powdered sanitizers with
extreme care. Physical or mechanical damage caused by improper handling or usage of
such products will not be the responsibility of ICCI.
DO NOT attempt to turn on whirlpool pump during the disinfectant cycle. Doing so
could result in skin or eye contact with the disinfectant, which is corrosive. If contact is
made, rinse immediately with water. If irritation occurs, consult a physician.
ALWAYS read and follow disinfectant label directions carefully.
NEVER use abrasive cleaners like scouring powder or liquid cleaners containing pumice
stone. The use of these types of cleaners will make the gel‐coat finish of your tub scratched
and dull. NEVER use cleaners containing iodine, bromine, Betadine
®
or methylene blue.
The use of these types of cleaners will cause the tub to stain. Never use cleaners containing
bleach. Use of these types of cleaners will dry out the rubber seals and gaskets and the tub
will not function properly.