Invacare 3600XL - Manual (Page 26)

SECTION 3—OPERATING INSTRUCTIONS
Side Entry Whirlpool Tub 26 Part No 1118387
Operating Shower/Massage Wand
NOTE: For this procedure, refer to FIGURE 3.4.
NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub.
1. Turn shower/massage wand on to desired flow by rotating shower On/Off valve
(Detail “A”).
2. Adjust water temperature using the water temperature valve while watching the flow
water thermometer (Detail “B”).
3. Adjust shower spray by rotating shower wand head (Detail “C”).
NOTE: Refer to following chart for shower head adjustment settings.
4. Turn shower On/Off valve to off position when finished.
FIGURE 3.4 Operating Shower/Massage Wand
Filling Tub
NOTE: For this procedure, refer to FIGURE 3.5 on page 27.
1. Close the drain (Detail “A”).
2. Turn tub fill On/Off valve to on position by rotating valve (Detail “B”).
3. Adjust water temperature using the water temperature valve while watching flow
water thermometer (Detail “C”).
CAUTION
Before starting hydromassage, water level MUST be completely above whirlpool
jets otherwise severe damage to the motor/pump will result.
4. Turn tub fill On/Off valve to off position when water reaches desired level (Detail “B”).
Stream
Shower Spray
Mixture of Spray and Pulse Massage
Pulse Massage
Water
Temperature
Valve
Flow Water
Thermometer
Shower On/Off Valve
Shower/Massage
Wand
Head
DETAIL “C” DETAIL “B” DETAIL “A”