Cleaning – Invacare 3600XL User Manual
Page 29
SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING
29
Cleaning
Cleaning the Door Seal Gasket
The rubber door seal gasket should remain clean and free of debris. Use a working
solution of a commercially available heavy duty cleaner such as Invacareʹs Heavy Duty
Cleaner and a sponge to thoroughly wipe the entire length of the rubber seal, making sure
to remove all traces of soap scum and other debris.
Removing Soap Film and Hard Water Deposits
Use a commercially available cleaner such as Invacareʹs Heavy Duty Cleaner to
thoroughly spray the exposed surfaces, including the openings of the tub jets and tub
suction fitting. Use a long handled soft brush or similar product to wipe down all surfaces
and allow the heavy duty cleaner to remain in contact with the exposed surfaces for
approximately ten minutes. Rinse off surfaces using the shower wand, adjusted to spray
position.
Removing Calcium Deposits, Scale and Lime Build-up
Spray a commercially available cleaner (full strength) for the intended application on all
surfaces to be cleaned. Allow the cleaner to remain in contact with surfaces for at least five
minutes to as long as 12 hours. Rinse off surfaces using the shower wand, adjusted to the
spray position. Use the cleaner according to the manufacturerʹs instructions.
Cleaning Your Tub
In addition to disinfecting your tub after every use, you will need to do the heavy duty
“Shock Treatment” approximately once every 80‐150 baths.