Electrical installation, Refer to electrical and – Invacare 3600XL User Manual
Page 17
SECTION 2—PARTS AND INSTALLATION
17
Electrical and Plumbing Hook-up Locations on the Tub
NOTE: For this procedure, refer to FIGURE 2.3 on page 17.
NOTE: For installation details refer to Electrical Installation on page 17 and Plumbing
Installation on page 20.
FIGURE 2.3 Electrical and Plumbing Hook-up Locations on the Tub
Electrical Installation
Ꮨ DANGER
When using electrical products, basic precautions should always be followed,
including the following:
RISK OF ELECTRIC SHOCK. Connect the bathtub only to a circuit protected by a
ground-fault circuit-interrupter (GFCI). Use a 15 AMP GFCI breaker only.
The National Electric Code requires the use of a ground fault circuit interrupter on
all therapeutic pools and tubs (hydrotherapeutic tanks). Failure to follow this
requirement could result in serious or fatal injury.
Grounding is required. The unit should be installed by a qualified service
representative and grounded.
ELECTRICAL SHOCK HAZARD. All disassembly and maintenance of the tub
MUST be done by a qualified technician, certified electrician or plumber. Be certain
all electrical work is in compliance with local electrical codes.
All electrical connections are to be water resistant.
Disconnect electrical supply or turn off the circuit breaker before performing any
maintenance to the tub.
All electrical conduit, fittings and wire to unit are to be supplied and installed by a
professional electrician in accordance with the National electrical code as a
minimum requirement, including the supply and installation of a Ground Fault
Circuit Interrupter (GFCI).
Before installing and connecting the tub, make certain that the electrical power
source is shut off to avoid electrical shock.
Electrical Line
Routing Hole
Cold Water Inlet
Hot Water Inlet
Model 3650
Models 3600 and 3600XL
Electrical Line
Routing Hole
¾-inch Hot
and Cold
Water Inlets
2-inch Drain PVC Pipe