Insignia 450TX - Manual (Page 9)

7
USING THE 450TX
SIMULATOR OPERATION
Actual depth capability depends on factors such as bottom hardness, water
conditions, and transducer installation. Units will typically read to deeper
depths in fresh water than in salt water
SIMULATOR OPERATION
The 450TX contains a simulator that allows
you to use the unit as if you are on the
water. The simulator is invaluable for
learning how to operate the 450TX.
There are two ways to start the simulator. If
the unit is powered off, press and hold the
POWER button for approximately three
seconds until you hear a continuous chirp.
The simulator can also be started by selecting the
Simulator option on the start-up screen after you
power-up the unit. When this screen is shown,
simply press the DOWN ARROW until “Simulator”
is highlighted. When the screen times out, the unit
will be in simulator mode.
Once the Simulator mode is selected, the next
screen will allow you to select either “down”
simulator or “side” simulator. The “down” selection simulates normal
operation of the unit with the Tri-beam transducer connected. “Down”
simulator is the default setting, so if no adjustment is made, the down
simulator will be selected. The “side” simulator simulates operation with a
Wide Side transducer connected. This is an excellent way to see if you like
the way the unit works using the optional Wide Side transducer.
When in simulator operation, the 450TX responds to control inputs as if it
is in actual operation, so feel free to experiment, or to customize the unit
for your particular operation.
To exit Simulator mode, power the unit off.
530977-1r11015E 11/6/01 12:09 PM Page 7