IBM xSeries 330 - Manual (Page 64)

56 Hardware Maintenance Manual: xSeries 330
Installing the microprocessor
Complete the following steps to install an additional microprocessor:
Attention: When you handle electrostatic discharge-sensitive devices (ESD), take
precautions to avoid damage from static electricity. For details on handling these
devices, refer to the following Web site and use a search term of ESD:
http://www.ibm.com/
1. Review the safety precautions listed in “Safety information” on page 107.
2. Turn off the server and peripheral devices and disconnect the power cord and all
external cables; then remove the cover (see “Removing the cover” on page 44 for
details).
3. Remove the clear shield from the server and store it in a safe place.
4. Lift up the microprocessor release lever and remove the terminator card from the
microprocessor connector. (After you remove the new microprocessor from the
static-protective package, place the terminator card in the bag and store it in a safe
place. You will need to install the terminator card again if you ever remove the
microprocessor and do not replace the microprocessor.)
5. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to any
unpainted metal surface on the server; then, remove the microprocessor from
the package.
b. Orient the microprocessor over the microprocessor connector as shown in the
illustration. Carefully press the microprocessor into the connector.
Note: To avoid bending the pins on the microprocessor, do not use excessive
force when pressing it into the connector.
Rear of server
Microprocessor
Microprocessor
connector
Microprocessor
orientation indicator
Microprocessor
release lever