Specifications – Integra DTR-9.1 User Manual
Page 76
Printed in Japan
D0004-1
E
Integra Division of
ONKYO U.S.A. CORPORATION
200 Williams Drive, Ramesy, N.J. 07446, U.S.A.
Tel: 201-825-7950 Fax: 201-825-8150 E-mail: [email protected]
Integra Division of
ONKYO CORPORATION
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN
Tel: 072-831-8111 Fax: 072-833-5222
SN 29342900
Specifications
TUNER SECTION
FM
Tuning Range:
87.5 — 108.0 MHz (50 kHz steps)
Usable Sensitivity
Mono:
11.2 dBf, 1.0 µV (75 ohms IHF)
0.9 µV (75 ohms DIN)
Stereo:
17.2 dBf, 2.0 µV (75 ohms IHF)
23 µV (75 ohms DIN)
50 dB Quieting Sensitivity
Mono:
17.2 dBf, 2.0 µV (75 ohms)
Stereo:
37.2 dBf, 20 µV (75 ohms)
Capture Ratio:
2.0 dB
Image Rejection Ratio
40 dB
IF Rejection Ratio:
90 dB
Signal-to-Noise Ratio
Mono:
76 dB
Stereo:
70 dB
Alternate Channel Attenuation:
55 dB
Selectivity:
50 dB (DIN)
AM Suppression Ratio:
50 dB
Total Harmonic Distortion
Mono:
0.2%
Stereo:
0.3%
Frequency Response:
30 Hz — 15 kHz, ±1.0 dB
Stereo Separation:
45 dB at 1 kHz
30 dB at 100 Hz — 10 kHz
AM
Tuning Range:
530—1,710 kHz (10 kHz steps)
Usable Sensitivity:
30 µV
Image Rejection Ratio:
40 dB
IF Rejection Ratio:
40 dB
Signal-to-Noise Ratio:
40 dB
Total Harmonic Distortion:
0.7%
GENERAL
Power Supply:
AC 120 V, 60 Hz
Power Consumption:
11 A
Dimensions (W
× H × D):
17-1/8"
Ч 7-11/16" Ч 18"
Weight:
49.4 lbs.
REMOTE CONTROLLER
Transmitter:
Infrared
Signal range:
Approx. 5 meters, 16 ft.
Power supply:
Two “AA” batteries (1.5 V
× 2)
Specifications and features are subject to change without
notice.
AMPLIFIER SECTION
Continuous Average Power output (FTC)
All channels:
130 watts per channel min. RMS
at 8 ohms, 2 channels driven
from 20 Hz to 20 kHz with no
m o r e t h a n 0 . 0 5 % t o t a l
harmonic distortion.
170 watts min. RMS at 6 ohms, 2
channels driven from 1 kHz with
no more than 0.1% total
harmonic distortion.
Continuous Power output (DIN)
160 watts at 6 ohms
Maximum Power output (EIAJ)
200 watts at 6 ohms
Dynamic Power Output (Stereo)
2
× 300 watts at 3 ohms
2
× 230 watts at 4 ohms
2
× 150 watts at 8 ohms
Total Harmonic Distortion:
0.05% at rated power
0.05% at 1 Watt output
IM Distortion:
0.05% at rated power
0.05% at 1 Watt output
Damping Factor:
60 at 8 ohms
Input Sensitivity and Impedance
PHONO:
2.5 mV, 50 kohms
LINE (CD, TAPE 1-2, DVD,
VIDEO 1-5):
200 mV, 50 kohms
MULTICHANNEL INPUT
(FRONT L/C/R, SURROUND
L/R, SURROUND BACK L/R): 200 mV, 50 kohms
(SUBWOOFER):
36 mV, 50 kohms
AMP IN (FRONT L/C/R) :
1 V, 50 kohms
COAXIAL 1-5 (DIGITAL):
0.5 Vp-p, 75 ohms
DVD, VIDEO1-5:
1 Vp-p, 75 ohms
1 Vp-p, 75 ohms (Y)
0.28 Vp-p, 75 ohms (C)
COMPONENT VIDEO 1-3:
1 Vp-p, 75 ohms (Y)
0.5 Vp-p, 75 ohms (P
B
, P
R
)
Output Level and Impedance
Rec out (TAPE 1-2, VIDEO 1-2):
200 mV, 2.2 kohms
Pre out:
1 V, 470 ohms
ZONE 2 OUT:
100mV, 470 ohms
VIDEO (VIDEO 1-2, MONITOR
OUT, ZONE 2 OUT):
1 Vp-p, 75 ohms
1 Vp-p, 75 ohms (Y)
0.28 p-p, 75 ohms (C)
COMPONENT VIDEO OUT:
1 Vp-p, 75 ohms (Y)
0.5 Vp-p, 75 ohms (P
B
, P
R
)
Phono Overload:
110 mV RMS at 1 kHz, 0.5% T.H.D.
Frequency Response:
20 Hz to 30 kHz : ±1dB
(CD in Direct mode)
5 Hz to 100 kHz : +1dB,-3dB
(CD in Direct mode)
RIAA Deviation:
20 to 20 kHz : ±0.8 dB
Tone Control
Bass:
±10 dB at 100 Hz
Treble:
±10 dB at 10 kHz
Signal-to-Noise Ratio (Stereo)
Phono:
80 dB (IHF A, 5 mV input)
CD/Tape:
100 dB (IHF A, 0.5 V input)