Intel D845PESV - Manual (Page 18)

Intel Desktop Board D845PESV Product Guide
18
Fan Connectors
Desktop Board D845PESV has two chassis fan connectors and one processor fan connector. See
Figure 11 on page 33 for the location of the fan connectors.
Fan Speed Control (Intel ® Precision Cooling)
Intel Precision Cooling automatically adjusts the chassis fan speeds depending on the system’s
temperature. This feature reduces system fan noise by lowering the speed of the chassis fans
connected to the front and rear chassis fan connectors (J9H3 and J6B2). The processor fan
connector (J2F1) is not controlled.
The fan speed control feature can be disabled in the BIOS, resulting in the chassis fans always
operating at full speed. This feature should be disabled if a self-controlled fan is attached to a
chassis fan connector.
Overall system noise reduction will vary based on system configuration and environment.
Resume on Ring
The operation of Resume on Ring can be summarized as follows:
•
Resumes operation from either ACPI S1 or ACPI S3 state
•
Requires only one call to access the computer
•
Detects incoming call similarly for external and internal modems
•
Requires modem interrupt be unmasked for correct operation
Wake from USB
USB bus activity wakes the computer from an ACPI S1 or S3 state.
✏
NOTE
Wake from USB requires the use of a USB peripheral that supports Wake from USB.
Wake from PS/2 Keyboard/Mouse
PS/2 keyboard/mouse activity wakes the computer from an ACPI S1 or S3 state.
PME# Wakeup Support
When the PME# signal on the PCI bus is asserted, the computer wakes from an ACPI S1, S3, or
S5 state.
Speaker
A speaker is mounted on the desktop board. The speaker provides audible error code (beep code)
information during the Power-On Self-Test (POST).