Intel D845PESV - Manual (Page 7)

7
1 Desktop Board Features
Table 1 describes the major features of Intel ® Desktop Board D845PESV.
Table 1. Feature Summary
Form Factor
•
ATX at 12.0 inches by 8.2 inches
Processor Support for:
•
533/400 MHz front side bus (FSB) Intel ® Pentium ® 4 processor in an
mPGA-478 socket
•
400 MHz FSB Intel ® Celeron ® processor in an mPGA-478 socket
Memory •
Up to two 184-pin Double Data Rate (DDR) SDRAM Dual Inline Memory
Modules (DIMMs) with gold-plated contacts. Supported memory
configuration are:
— DDR333: to run DDR333 memory at full speed requires an Intel
Pentium 4 processor with 533 MHz front side bus frequency (FSB)
— DDR333 memory will run only at DDR266 speeds when using a
processor with 400 MHz FSB
— DDR266: requires an Intel Pentium 4 processor with
533/400 MHz FSB, or Intel Celeron processor with 400 MHz FSB
— DDR200: requires an Intel Pentium 4 or Intel Celeron processor with
400 MHz FSB
•
Unbuffered and non-registered single or double-sided DIMMs
•
Serial Presence Detect (SPD) memory only
•
Non-ECC RAM (ECC memory will run in non-ECC mode)
•
2.5 V memory
NOTE: Desktop Board D845PESV has been designed to support DIMMs based on
512 Mbit technology up to 2 GB, but this technology has not been validated on this Intel ®
desktop board. For more information about the latest list of tested memory, refer to the
Intel World Wide Web site at:
http://support.intel.com/support/motherboards/desktop/
Chipset
•
Intel ® 845PE chipset consisting of:
•
Intel ® 82845PE Memory Controller Hub (MCH) with Accelerated Hub
Architecture (AHA) bus
•
Intel ® 82801DB I/O Controller Hub (ICH4) with support for up to six
Hi-Speed Universal Serial Bus 2.0 (USB 2.0) ports
•
4 Mbit Firmware Hub (FWH)
I/O Control Support for:
•
SMSC LPC47M172
•
National Semiconductor PC87372
Audio
•
Intel 845PE chipset (AC ’97)
•
Analog Devices Inc. audio codec
LAN (optional)
•
Intel ® 82562ET 10/100 Mbit/sec Platform LAN Connect (PLC) device and
RJ-45 connector
continued