Jensen Smart Talk JCR-290 - Manual (Page 14)

E-13
TO SET THE ALARM WAKE SOUNDS (AL1/AL2)
1. Start by saying the trigger word “Smart Talk” or press the
SNOOZE BAR (#11).
2. The unit will reply “Yes” and will wait for your next command.
3. Say “Alarm Sound” and the unit will reply “To set alarm sound,
please say Alarm One or Alarm Two”.
4. To set Alarm One, say “Alarm One”. You can also say the
command “Cancel” during this step if you wish to cancel setting
the alarm sound.
5. If the unit fails to understand the alarm source given, it will reply,
“Please Repeat”. Now repeat step #4 above.
6. If the unit fails to understand the alarm source given a second time,
it will reply “I’m sorry. I did not understand you, please start
over or set the alarm sound manually”. If this occurs, repeat
steps #1 - 4 above again making sure you speak clearly in a normal
voice.
7. When the alarm source is successfully understood, the unit will reply,
“To choose an alarm sound, say Ocean, Rain, Brook, Radio or
Beep”.
8. Say Ocean, Rain, Brook, Radio or Beep. You can also say the
command “Cancel” during this step if you wish to cancel setting the
alarm sound and the unit will reply “OK” to confirm.
9. When the alarm sound is successfully understood, the unit will
reply “Alarm One sound is set to…” and repeat the alarm sound
you have chosen. The alarm one sound selected will light in the
display (#25).
10. If the unit fails to understand the alarm sound given for the first and
second times, it will reply “Please Repeat”. Now repeat step #8
above.
11. If the unit fails to understand the alarm sound given a third time, it
will exit with further prompt message.
12. To set Alarm Two Sound, repeat steps #1 – 4 and 8 above and
say “Alarm Two” when prompted (step #4). The alarm two sound
selected will light in the display (#26) when completed.