Jensen Smart Talk JCR-290 - Manual (Page 18)

You can choose either a nature sound (Ocean, Rain or Brook) or the
radio as a sleep sound.
The sleep time can be adjusted from: 15, 30, 45 or 60 minutes and OFF.
MANUAL SETTING
SETTING THE SLEEP SOUND
1. The Sleep Sound can be set by repeatedly pressing the SET
BUTTON until you get to the to Sleep Sound settings.
2. Use the > (UP) (#6) or < (DOWN) (#4) BUTTONS to choose a Sleep
Sound (Ocean, Rain, Brook or Radio).
3. The display will show the chosen Sleep sound (#27).
SETTING UP THE SLEEP SOUND AND TIME
USING SMART TALK™
1. When the designated alarm time is reached, there will be a periodic
pause in the alarm sound if you chose a nature sound (Ocean,
Rain or Brook) or the Beep for your wake alarm. This is normal and
during the pause is where the unit is listening for the “Alarm Off”
command.
2. Say “Alarm Off” during one of the pauses in the alarm sound to
turn the Alarm off for the day. If the “Alarm Off” command is
correctly recognized, the unit will reply “Yes” and the alarm sound
will stop. The alarm will sound again the next day at the same
preset time.
3. If radio is chosen as the alarm sound, it will play without interruption
and therefore you will not be able to use Smart Talk “Alarm Off”
command to turn it off. The radio alarm will have to be turned off by
pressing either AL1 ON/OFF (#2), AL2 ON/OFF (#8) or ON/FF (#12)
BUTTON.
4. Follow the steps in the above Smart Talk section “TO CHECK THE
ALARM TIME (AL1/AL2)” to turn the specific alarm off with voice
commands if it is initially on. The corresponding alarm indicator on
the display (#25 and/or #26) will turn off to confirm.
E-17