Jensen Smart Talk JCR-290 - Manual (Page 8)

INSTALLING BACKUP BATTERIES
1. Remove the BATTERY COMPARTMENT COVER.
2. Install 2 x 3V type CR2032 Lithium batteries (not included)
according to the polarity indications on the BATTERY
COMPARTMENT COVER.
3. Close the BATTERY COMPARTMENT COVER.
NOTE: The unit will operate without batteries installed, but your time and
alarm settings will be lost and have to be reset in the event of a power
interruption or failure.
IMPORTANT: Be sure that the batteries are installed correctly.
Wrong polarity may damage the unit and void the
warranty.
For best performance and longer operating time, we
recommend the use of good quality batteries.
CAUTIONS
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
3. If the unit is not to be used for an extended period of time, remove
the batteries. Old or leaking batteries can cause damage to the unit
and may void the warranty.
4. Do not dispose of batteries in fire, batteries may explode or leak.
5. Replace all the batteries, no matter exhausted or not, every 2 years
at the same time to avoid possible battery leakage.
CONNECTING THE UNIT TO AC POWER SOURCE
Please be sure the outlet you plug this unit into is working and provides
uninterrupted power.
1. Insert the AC plug of the AC power cord into a 120V~ 60Hz outlet.
2. Press the RESET BUTTON on the bottom of the unit with a pointed
object (e.g. a straighten paper clip) to initialize. After a brief self test,
the unit enters the clock mode.
3. To listen to the radio, press On/Off Button.
E-7