Jensen Smart Talk JCR-290 - Manual (Page 20)

1. Select your desired radio band using the BAND SELECTOR (#7) for
AM or FM.
2. Press the ON/OFF BUTTON (#12) to turn radio on.
3. Rotate the TUNING CONTROL (#9) to your desired radio station
according to the dial scale on the unit.
4. Rotate the VOLUME CONTROL (#1) to adjust to the desired output
level.
5. To turn off the radio, press the ON/OFF BUTTON (#12).
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM
reception is weak, change the position of unit until the internal
antenna picks up the strongest signal.
FM – During FM reception, always keep the FM WIRE ANTENNA
(#21) fully extended for best performance. However, if FM
reception is weak, try repositioning the unit near an open
window until you get the best reception.
LISTENING TO RADIO
You may playback your favorite music from your iPod or a portable
digital audio player using the Line in function.
1. Connect the headphone jack of your external device to the LINE IN
JACK (#18) at the rear cabinet of this unit using a stereo cord with
a 3.5mm phone plug on either ends. (Note: the stereo cord is not
included).
USING THE LINE IN TO LISTEN TO EXTERNAL
AUDIO PLAYER
E-19
NOTE:
- During sleep, you may press the SLEEP BUTTON (#10) to check
the remaining sleep time.
- When sleep sound is playing, its volume can be adjusted from low
to high (level 1-4) by pressing the > (UP) (#6) or < (DOWN) (#4)
BUTTONS. The selected sleep sound volume will be displayed.
- To change the sleep sound during sleep, press the SNOOZE BAR
(#11) and use “Play Sleep Sound” voice command to change it
as usual. The remaining sleep time will not be affected.