JVC 0803AIMMDWJEM - Manual (Page 57)

54
English
3
Select the source to record from.
1) Press ¢ or 4 repeatedly
to select the source.
• Each time you press the
button, the source changes as
follows:
2) When you select “FM” or “AM,” press SET, then
select a preset number by pressing ¢ or 4.
When you select “AUX,” set the timer function of the
external component as well.
3) Press SET.
A device to record onto flashes on the
display.
4
Select the device to record onto.
1) Press ¢ or 4 repeatedly
to select the device.
2) Press SET.
3) When you select “MD REC,” select the recording
length mode (see page 30) by pressing ¢ or 4,
then press SET again.
When you select “TAPE REC,” select
Reverse Mode (see page 26) by pressing
REV.MODE when you prepare the
device.
When recording starts, reverse mode indicator changes
to
automatically.
The hour digits of the start time start flashing.
There are three timers available—Recording Timer, Daily
Timer and Sleep Timer.
• Before using these timers, make sure the built-in clock is
set correctly (see page 9).
• When using the tuner as the source, preset stations in
advance (see page 14).
Using Recording Timer
With Recording Timer, you can make an unattended
recording.
• You can set Recording Timer whether the unit is turned on
or off (on standby).
• To correct a mis-entry any time during the setting process,
press CANCEL.
• To exit from the timer setting during the process, press
CLOCK/TIMER repeatedly until the source indication
appears.
How Recording Timer actually works
The unit automatically turns on, muting the volume, and
starts recording on the MD or on the tape when the start time
comes. Then, when the shut-off time comes, the unit
automatically turns off (on standby).
Recording Timer works only once, but the timer settings
remain stored in memory until you reset them or unplug the
AC power cord.
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly
until “REC TIMER” appears on
the display.
The (timer) indicator lights up and the
REC (recording timer) indicator starts flashing on the
display.
• Each time you press the button, the timer changes as
follows:
2
Press SET.
The source name flashes on the display.
Using the Timers
CLOCK/
TIMER
REC
REC TIMER DAILY TIMER
Clock setting Source indicator
(canceled)
GROUP SKIP GROUP SKIP
SET
GROUP SKIP GROUP SKIP
SET
MD REC TAPE REC
SET
FM AM AUX
Continued
GROUP SKIP GROUP SKIP
SET
REV.
MODE
SET
GROUP SKIP GROUP SKIP
EN54-58_UX-J55MD[UB]f.p65 7/1/03, 4:44 PM 54