JVC CA-UXEP25 - Manual (Page 13)

10
To display the clock indication
Remote
ONLY
While the System is turned on...
• Press the button again, to return to the source
information.
Listening to the Radio
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with suffi cient
signal strength is tuned in, the frequency stops
changing.
• When you repeatedly press the button, the
frequency changes step by step.
To stop searching manually, press either button.
If the received FM station is hard to listen Remote
ONLY
MONO : Reception will improve though
stereo effect is lost. MONO
indicator lights up.
STEREO : Normally select this. Stereo effect
will be resumed.
To restore the stereo effect, press the button
again (the MONO indicator goes off).
To preset the stations
Remote
ONLY
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
2 Activate the preset number entry mode.
• Finish the following process while the indica-
tion on the display is fl ashing.
3 Select a preset number for the station
you store.
Examples:
To select preset number 5,
press 5.
To select preset number 15,
press >
=10
J 1 J 5.
To select preset number 20,
press >
=10
J 2 J 0.
4 Store the station.
Remote control: Main unit:
1 sec. 1 sec.
FM AM
AUX USB AUDIO
MONO
STEREO