Playing back from the pc, How to install the usb drivers – JVC CA-UXEP25 User Manual

Page 18

Advertising
background image

15

Resume Play for MP3/WMA

If you press

7 while playing MP3/WMA, the number

of the track where you have stopped playback will be
memorized by the unit.
By pressing CD

6 or USB MEMORY 6, you can

start playback again from the beginning of the same
track.

To activate/cancel resume play

Remote
ONLY

memo

Pressing OPEN/CLOSE (for Disc), or

disconnecting the USB mass storage class
device will erase the track number for
resume play.

To play back from the fi rst track while

resume play is activated, press

7 twice

during playback.

Playing Back from the PC

This System is equipped with a USB terminal on
the rear panel. You can connect your PC to this
terminal and enjoy the sound out of your PC.
When you connect your PC for the fi rst time,
follow the procedure below.
Remember you cannot send any signal or data

to your PC from this System.

IMPORTANT

Always set volume to “VOLUME MIN” when

connecting or disconnecting the other equipment.

.

How to install the USB drivers

1

Turn on your PC and start running Win-

dows

®

98SE, Windows

®

Me, Windows

®

2000, or Windows

®

XP.

If the PC has been turned on, quit all the ap-

plications running.

2

Select USB AUDIO for the source.

3

Connect the System to the PC using a

USB cable (not supplied).

Use

USB series A plug to B plug cable.

4

The USB drivers are installed automati-

cally.

To play back sounds on the PC

Refer to the manuals supplied with the sound
reproducing application installed in the PC.

* Microsoft

®

, Windows

®

98SE, Windows

®

Me, Windows

®

2000 and Windows

®

XP

are registered trademarks of Microsoft
corporation.

memo

DO NOT turn off the unit or disconnect the

USB cable while installing the drivers and for
several seconds while your PC is recognizing
the receiver.

Use a full speed USB cable (version 1.1).

Recommended cord length is shorter than
approximately 2 m.

If your PC does not recognize the unit,

disconnect the USB cable and connect it again.
If it does not work yet, restart Windows.

The installed drivers can be recognized only

when the USB cable is connected between the
unit and your PC.

The sound may not be played back correctly—

interrupted or degraded—due to your PC
settings and PC specifi cations.

(rear panel)

USB cable

PC

RESUME ON

RESUME OFF

FM

AM

AUX

USB AUDIO

Advertising