JVC HR-J449MS - Manual (Page 15)

15
If Auto Set Up has been performed successfully:
1
Turn on the TV and select its AV mode, then make sure that all necessary stations have been stored in the recorder's memory
by using the CHAINE button(s).
● If station names (ID — ੬
pg. 21) have also been stored in the recorder's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds when the channel is changed.
● If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station
names, see pages 18 – 21.
2 Perform "S HOW V IEW Setup" on page 24 to check if the Guide Channels have been set correctly.
If auto channel set has succeeded but auto clock set has not:
1
Turn on the TV and select its AV mode, then make sure that all necessary stations have been stored in the recorder's memory
by using the CHAINE button(s).
● If station names (ID — ੬
pg. 21) have also been stored in the recorder's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds when the channel is changed.
● If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station
names, see pages 18 – 21.
2 Perform "Clock Set" on page 22, then "S HOW V IEW Setup" on page 24 to check if the Guide Channels have been set correctly.
If both auto channel set and auto clock set have failed:
1 Make sure the TV aerial cable is connected properly to the recorder and turn off the recorder power once, then turn the
recorder power back on again.
● The recorder will try Auto Set Up again.