JVC XV-N55SL - Manual (Page 11)

6
NOTES
• If the AM (MW) loop antenna wire is covered with
vinyl, remove the vinyl while twisting it as shown on
the right.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord.
This could cause poor reception.
Snap the tabs on the loop
into the slots of the base to
assemble the AM (MW) loop
antenna.
Connecting the FM and AM (MW) antennas
AM (MW) loop
antenna (supplied)
If AM (MW) reception is poor, connect an outdoor single
vinyl-covered wire (not supplied).
AM (MW) antenna connection
Connect the AM (MW) loop antenna supplied to the AM LOOP
terminals.
Connect the white cord to the AM EXT terminal, and the black cord to
H terminal.
Turn the loop until you have the best reception.
• If the reception is poor, connect an outdoor single vinyl-covered
wire (not supplied) to the AM EXT terminal. Keep the AM (MW) loop
antenna connected.
FM antenna connection
Connect the FM antenna supplied to the FM 75 Ω COAXIAL terminal
as temporary measure.
Extend the supplied FM antenna horizontally.
• If the reception is poor, connect an outdoor FM antenna (not
supplied). Before attaching a 75 Ω coaxial cable with a connector
(IEC or DIN 45325), disconnect the supplied FM antenna.
COAXIAL
AM LOOP
ANTENNA
DVD
IN
AUDIO
L
R
L
R
FM 75
AM EXT CENTER
FRONT
AV IN / OUT
AV IN
SUBWOOFER
OUT
DIGITAL IN DIGITAL 3
(TV)
DIGITAL 2
(STB)
DIGITAL 1 (DVD)
CENTER SPEAKER SURROUND SPEAKERS
RIGHT LEFT RIGHT LEFT
FRONT SPEAKERS
SUB
WOOFER SURR (REAR)
CAUTION:
SPEAKER
IMPEDANCE
8 ~ 16
DVD STB
VCR TV
FM 75
COAXIAL
COAXIAL
AM LOOP
ANTENNA
FM 75
AM EXT
RX-ES1SL
1 3 2
If FM reception is poor, connect
outdoor FM antenna (not supplied).
FM antenna (supplied)
Getting started
01-10.RX-ES1&XV-N55[B]f 03.2.18, 1:47 PM 6