JVC XV-N55SL - Manual (Page 27)

22
Setting the subwoofer audio position
When a stereo source is played back, the subwoofer sound is
reinforced compared to the sound from a multi-channel source.
Once you have set the subwoofer audio position, the subwoofer
output level is decreased by the selected value when a stereo source
is played back. The A (audio).POSITION indicator lights up when this
function is activated.
• You have to make this adjustment for each source.
From the remote control ONLY:
Press A.POSTION repeatedly to select
the subwoofer audio position level
from “–2 (dB),” “–4 (dB),” and “–6 (dB).”
The smaller the number becomes, the more the
level decreases automatically when listening in
stereo.
• If no adjustment is required, select “OFF” (initial
setting).
NOTES
• The maximum subwoofer output level is –10 dB.
Ex:
When setting the subwoofer output level to “
−8 (dB)” and the
subwoofer audio position to “ −4 (dB),” the subwoofer output level
when listening in stereo will be −10 dB.
• This function does not take effect when activating a Surround
mode.
Adjusting the front speakers output
balance—BAL
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speakers output balance.
• You have to make this adjustment for each source.
• You cannot use the remote control for this setting.
BAL*: To adjust the front speakers balance.
• “CENTER” to “L-21”: Decrease the left channel output.
• “CENTER” to “R-21”: Decrease the right channel
output.
* “CENTER” is the initial setting.
Sound adjustments
AUDIO
ZOOM
ANGLE
REPEAT
DIMMER
SUBWFR CENTER L R SURR
BASS BOOST A.POSITION SMART S. SETUP
SLEEP CANCEL
SURROUND
ANALOG/DIGITAL
TV RETURN 100+
BASS TREBLE
SUBTITLE RETURN TITLE/GROUP
BASS TREBLE
1 2 3
4 VFP
INPUT
TONE
TEST EFFECT DECODE
5 6
7 8 9
10
3D
0 +10
AUDIO
ZOOM
ANGLE
REPEAT
DIMMER
SUBWFR CENTER L R SURR
BASS BOOST A.POSITION SMART S. SETUP
SLEEP CANCEL
SURROUND
ANALOG/DIGITAL
TV RETURN 100+
BASS TREBLE
SUBTITLE RETURN TITLE/GROUP
BASS TREBLE
1 2 3
4 VFP
INPUT
TONE
TEST EFFECT DECODE
5 6
7 8 9
10
3D
0 +10
Reinforcing the bass—B.BOOST
You can boost the bass level—Bass Boost.
• You have to make these adjustments for each source.
ON: Select to boost the bass level (Bass Boost).
The BASS BOOST indicator lights up on the display.
OFF*: Select to deactivate Bass Boost.
* Initial setting
NOTE
This function affects the sound coming out only through the front
speakers.
When using the remote control:
Press BASS BOOST.
• Each time you press the button, Bass Boost
turns on and off alternately.
Attenuating the input signal—ATT
When the input level of analogue source is too high, the sound will
be distorted. If this happens, you need to attenuate the input signal
level to prevent the sound distortion.
• You have to make this adjustment for each analogue source.
• You cannot use the remote control for this setting.
ON: Select to attenuate the input signal level.
The INPUT ATT indicator lights up on the display.
NORMAL*: Select to deactivate attenuation.
* Initial setting
21-22.RX-ES1&XV-N55[B]f 03.2.18, 1:46 PM 22