JVC VN-C205 - Manual (Page 11)

11
^ Focal length adjustment ring
Use the fastening screw adjustment ring to
set the image size and fix it with fastening
screw. (
☞
Page 24)
& Focus ring
Use the fastening screw adjustment ring to
set the focus and fix it with fastening screw.
(
☞
Page 24)
Video setting switch
* [D/N - ON/OFF] Easy Day & Night switch
To capture a subject with continually chang-
ing brightness (day/night), set this switch to
“ON”. The camera automatically captures the
image in color when the subject is bright, and
in black and white mode when it is dark.
(Default setting: OFF)
Caution
The Easy Day & Night feature on this
camera uses a sensitized black and white
mode unlike other black and white
surveillance cameras that use infra-red
lighting.
( [FOCUS ADJ. - ON/OFF] focus adjustment
switch
When adjusting the focus during installation,
setting this switch to “ON” will open the
iris.(Default setting: OFF) (
☞
page 24)
) [AGC - ON/OFF] Auto-gain control switch
Setting this switch to “ON” automatically in
creases the sensitivity even when the bright
ness of the subject is insufficient.
(Default setting: ON)
⁄ [BLC - ON/OFF] Backlight Compensation
switch
Setting this switch to “ON” opens the iris even
in backlight conditions, making the subject
easier to view.
(Default setting: OFF)
¤ [AUTO/MANU] White Balance Automatic/
Manual switch
For selecting whether to adjust the white bal-
ance automatically or manually.
(Default setting: AUTO)
‹ [R/B] Manual WHITE adjustment button
This button is pressed when manually adjust-
ing the white balance.
This feature is enabled when the “MANU” is
selected using
¤ [AUTO/MANU] switch.
Press the B button to increase the blue tint
and decrease the red tint.
›
[RESET] Manual WHITE reset button
When this button is pressed, the value of the
white balance adjusted manually is reset to
the default value.
fi [SPOT CORRECTION] White-spot correc-
tion button
When this button is pressed, white spots are
corrected.
For instructions on correcting white-spots, see
“About White-spot correction”.
(
☞
page 26)
% [10BASE-T/100BASE-TX] 10BASE-T/
100BASE-TX Terminal
This is a 10BASE-T/100BASE-TX terminal.
It is used for connecting to the network via
LAN cables. (
☞
Page 20)
Signal Name
Alarm Output
Alarm Input
Alarm Output 1
Alarm Output 2
Alarm Input 1
Alarm Input 2
GND
1
2
3
4
5
Pin No.
C205_p2-26 05.7.5, 10:31 AM 11