JVC VN-C205 - Manual (Page 42)

42
1 Alarm 1/Alarm 2
Mode
Detect Mode
Alarm Output
Message Packet
Alarm FTP
Shutdown
Ⅵ Alarm Input
Item Function/Set Value
This section describes setting procedures for alarm input.
For selecting whether to enable or disable the input signals.
Set Values : Available, Not Available
For selecting the method for detecting input signals.
Make
: Detect input signals at the "Make" contact point.
Break : Detect input signals during "Break".
Toggle : Detect input signals at both "Make" and "Break".
For selecting whether to output from the alarm output terminal
when there is alarm input.
Not Available : Do not output from the alarm output terminal.
Alarm Output 1 : Send output from the Alarm Output 1 terminal.
Alarm Output 2 : Send output from the Alarm Output 2 terminal.
For setting whether to send alarm packets to the PC when there
is alarm input.
Not Available : Do not send alarm packets.
Available
: Send alarm packets.
For operation according to the [Alarm FTP] in the FTP Client
feature when there is alarm input. Please refer to FTP Client
Settings (
☞
Page 50) for details on alarm FTP.
Set Values: Available, Not Available
Set to "Available" to quit all operations upon alarm input. Using
this Shutdown function enables operations of this camera to
end safely even during recording into CF cards.
Not Available : Do not shut down.
Available
: Shut down.
2-4 Other Settings Using the "VN-C205U Setup Tool" (4. Alarm Setting) (Continued)
Settings (Step 2 Network Settings)
Initial Value
—
Not Available
Make
Not Available
Not Available
Not Available
Not Available
Note
• Unless the alarm output in the "Alarm Output" tab is enabled,
this function will not be activated even if alarm output is
selected in the alarm input settings. (
☞
Page 44)
Note
• When this is set to "Available", all alarm input except alarm
output and message packets will be disabled.
C205_p27-45 05.6.28, 11:45 AM 42