JVC VN-C205 - Manual (Page 63)

63
1 Message
Message entered in the textbox will be
displayed when there is an alarm input.
(Up to 100 single-byte characters)
2 Recording
Starts recording when there is an alarm input.
Non-stop : Recording continues until the Stop
button is pressed.
1 minute : Recording stops after 1 minute.
3 Playing wave file
Plays back a designated Wave file when there
is an alarm input. Click the [Browse] button to
specify a file.
4 Execute application file
Executes a designated program when there
is an alarm input. Click the [Browse] button to
specify a program.
Notes
● The [1 minute] mode is used for conserving
hard disk space.
● In this mode, recording stops after 1 minute
even if recording has already started
before the alarm input.
Note
Alarm actions may be delayed due to PC
performance if a large Wave file (.wav) is
selected.
Notes
Alarm Operation
The following settings are required for the operation of the set alarm.
1. [Alarm Reg] is checked. This item is located under the [Setting] menu of the "V. Networks
Controller". (
☞
Page 57)
2. All alarm settings in the [Alarm Setting] of the "VN-C205U Setup Tool" are enabled. (
☞
Page 40)
Relay Alarm
When the Relay Alarm function is enabled, subsequent alarms will not be activated.
C205_p56-p65 05.6.27, 11:26 AM 63