JVC VR-N100U - Manual (Page 80)

VR-N100U USERS MANUAL
Page 80 of 98 All Items Are Subject To Change Without Notice Feb. 2004 Rev 1.0
6.2. Jumper Settings
The Industrial Server Board utilizes multiple default jumper settings for use with the VR-N100U security appliance and they are
outlined in the following sections.
6.2.1. JP1: Flash Disk
Options Settings
Master 1-2: Short
Slave 1-2: Open (default)
The embedded VR-N100U operating system and application are stored on a non-volatile flash disk that is attached to
the IDE 0 Channel. The setting for the flash should always be set to MASTER and no other device should be
attached to the IDE 0.
NOTE: DO NOT attempt to change the Flash Disk default setting on your VR-N100U unless instructed by Technical
Support personnel.