JVC VR-N100U - Manual (Page 87)

VR-N100U USERS MANUAL
Page 87 of 98 All Items Are Subject To Change Without Notice Feb. 2004 Rev 1.0
CMOS failure
NIC failure
SCSI failure
LED RED GREEN DESCRIPTION
On Off POST (Power On Self-Test)
Flash 1 Off ROM Checksum Error
Flash 2 Off Memory Error
Flash 3 Off Error as No Bootable Disk
STATUS
On On Boot up into OS
On/Flash Off Software Controlled
Off On/Flash LAN1 Hardware Activity NETWORK
Off Off No Network Activity
On Off LAN1 10Mbit Ethernet Connection
Off On LAN1 100Mbit Ethernet Connection 10/100
Off Off LAN1 is not Connected
On/Flash Off Device Activity on SCSI Bus
Off On/Flash Device Activity on IDE Channel(s) DEVICE
Off Off No Device Activity
6.6. Power Supply
The board is also unique in that it has been designed to support the two most common types of power supplies used today
(AT and ATX). This flexibility will allow it to be installed in nearly all enclosures. The ATX power supply is recommended and
comes standard with all VR-N100U rackmount systems.
NOTE1:
When selecting the ATX power adapter, do not forget to attach an ATX power switch to CN6 pin set.