Jaguar X-Type JJM 21 02 20/15 - Manual (Page 135)

Roadside emergency 6-13
Dip beam (outer) headlight
Open the bonnet.
Slide open the two spring clips and remove the cover.
Turn the bulb holder a quarter turn anti-clockwise and remove
the bulb and holder from the light unit.
Fit a new bulb to the holder, type H1 for dipped beam.
Fit the holder to the light unit, the bulb will only correctly fit in
one position.
Fit the cover and retain using the two spring clips.
Close the bonnet.
Note: High Intensity Discharge (HID) Xenon light units,
type D2S 35W, are not renewable, contact your Dealer if the
headlight fails to operate.
Side repeater indicator – bulb renewal
Remove the light unit by pushing the lens towards the front of
the vehicle to compress the spring clip and then pull the rear
outwards to remove the complete unit.
Twist the bulb holder anti-clockwise and pull it from the lens.
Pull the capless bulb from the holder and fit a new one of the
correct type, W5W. Fit the bulb holder to the lens.
Place the inner rear of the lens unit into the recess and then
push the front of the lens inwards until it clicks into place.