JVC CA-UXG45 - Manual (Page 52)

13
English
Playing Back a Tape
To insert a tape
You can play back type I tapes.
Playing Back Other Equipment
To connect other equipment
By using an stereo mini plug cord (not supplied), you can
connect equipment with analog audio output jacks such as a
Digital Audio Player, or a TV, etc.
If the audio output on the other equipment is not stereo
mini plug type,
Use a plug adapter to convert the stereo mini plug to the
corresponding plug of the audio output.
Refer to the manuals supplied with the other equipment.
To adjust the sound input level from other
equipment
You can adjust the sound input level from the connected
equipment, if the incoming signal is too small or too large.
1
Select AUX for the source.
2 Adjust the input level.
AUX LVL 1: Ordinary input level (factory setting).
Suitable for equipment with low output level
(such as a portable audio device).
AUX LVL 2: Decreased input level.
Suitable for equipment with high output level
(such as a DVD player).
memo
• If you feel that the output level from the external
equipment is high, select AUX LVL2.
To start: To stop:
To rewind tape:
IMPORTANT
• Always set volume to “VOL-MIN” when connecting or
disconnecting the other equipment.
Push Insert Close
With the tape side facing front
Wind forward the tape.
Rewind the tape.
AUX
(front panel)
Stereo mini plug cord (not supplied)
Portable audio
device,
Game machine, etc.
SET/RESUME AUX LVL 1
AUX LVL 2
2 sec.
UX-G45[UW].BOOK Page 13 Tuesday, May 30, 2006 2:07 AM