Jura Capresso IMPRESSA S9/S7 - Manual (Page 14)

14
ț Temperature
ț Water portion
ț Steam portion
ț Economy mode
ț Time
ț Automatic switch-on time
ț Automatic switch-off time
ț Language
ț Display
ț Information (to be viewed only)
13.1 Programming the filter
Please refer to Chapter 5 “Using the CLARIS plus filter cartridge”.
13.2 Programming your machine to the correct
water hardness (only with FILTER NO)
Please refer to Chapter 4 “Adjusting your machine to the water
hardness”.
13.3 Maintenance
You can activate the following maintenance functions from this
program item:
RINSE MACHINE, CLEAN MACHINE, DE-SCALE MACHINE,
CHANGE FILTER.
“DE-SCALE machine” is not displayed if you are using a CLARIS
plus filter and the filter is set to “YES”.
“CHANGE FILTER” is not displayed if you are not using a
CLARIS plus filter and the filter is set to “NO”.
Ⅲ
SELECT PRODUCT
Ⅲ Open the programming door (3). Press the Rotary Switch (4)
until you hear an acoustic signal.
Ⅲ
FILTER
NO or YES
Ⅲ Turn the Rotary Switch (4) until the following message is dis-
played:
Ⅲ
RINSE
Ⅲ Now press the Rotary Switch (4) to start programming.
Ⅲ
RINSE
MACHINE
Ⅲ Turn the Rotary Switch (4) until the required maintenance func-
tion (for selection see above) is displayed. Press the Rotary
Switch (4) to activate the function.
The Maintenance menu closes automatically after 5 seconds
if no function is selected.
13.4 Programming the amount of powder for coffee
and espresso
You can adjust the amount of powder for coffee and espresso
separately.
Ⅲ
SELECT PRODUCT
Ⅲ Open the programming door (3). Press the Rotary Switch (4)
until you hear an acoustic signal.
Ⅲ
FILTER
NO or YES
Ⅲ Turn the Rotary Switch (4) until the following message is dis-
played:
Ⅲ POWDER
QUANTITY
Ⅲ Now press the Rotary Switch (4) to start programming.
Ⅲ
SELECT
PRODUCT
Ⅲ Then press a product key of your choice.