Jura Capresso IMPRESSA S9/S7 - Manual (Page 24)

24
Ⅲ
EMPTY TRAY /
EMPTY GROUNDS
Ⅲ Empty out the drip tray (1) and integrated coffee grounds bin.
Ⅲ
TRAY
MISSING
Ⅲ Place the empty, clean drip tray (1) and integrated coffee
grounds bin back into the IMPRESSA.
Ⅲ SELECT PRODUCT
Ⅲ When the cleaning program has finished, take out the removable
coffee powder tank and briefly rinse it under running water.
You can also trigger a cleaning cycle manually at any point
in time (see Chapter 13.3).
16. Decalcifying
The IMPRESSA features an integrated decalcifying program. The
process takes approx.50 minutes.
Lime scale builds up in the IMPRESSA as a result of normal
use. The degree of calcification depends on the hardness of
the water you use. The IMPRESSA recognizes when you
should run a decalcifying cycle. The machine will still make
coffee and hot water/steam. However, we recommend that
you should decalcify the machine within a few days after the
message was displayed.
Please contact your authorized dealer for JURA decalcifying
tablets that are suitable specifically for the decalcifying
program of your IMPRESSA. Please note that the use of
unsuitable decalcifying agents may cause damage to your
machine and could leave unfavourable residues in the water.
Remove any splashes or drops of the decalcifying agent from
sensitive surfaces, in particular surfaces made of natural
stone or wood, or take appropriate preventive measures.
Once started, the decalcifying program must not be inter-
rupted.
Always wait until the decalcifying agent has been used up
and the tank is empty. Never fill in additional decalcifying
agent.
Ⅲ
SELECT PRODUCT
DE-SCALE MACHINE
Ⅲ Press Rinse
until the following message appears:
Ⅲ
EMPTY TRAY /
EMPTY GROUNDS
Ⅲ Empty out the drip tray (1) and integrated coffee grounds bin.
Ⅲ
TRAY
MISSING
Ⅲ Place the empty, clean drip tray (1) and integrated coffee
grounds bin back into the IMPRESSA.
Ⅲ
AGENT IN TANK /
PRESS STEAM
Ⅲ Take out the water tank (14). Empty out any remaining water.
Completely dissolve the content of one blister (3 tablets) in a
receptacle containing 0.6 litres of water, and pour the mixture into
the water tank. Place the water tank back into the machine.
Ⅲ Remove the 2-stage frothing jet (24) or Professional-Cappuccino
Frother from the machine (if attached).
Ⅲ Place a tall receptacle under the pivoting steam spout (23) and
press one of the Steam keys .
Ⅲ
MACHINE
DE-SCALING
Ⅲ You will hear an acoustic signal.
Ⅲ
OPEN TAP
Ⅲ Place the receptacle under the hot water spout (25).