JVC CA-UXHB4 - Manual (Page 10)

7
Connecting Speakers
You can connect the speakers using the speaker cords.
1 Hold the clamp of the speaker terminal.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: red cord to
ª and black cord to ·.
3 Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one
speaker terminal.
Red
Red
Black
Black
Speaker
cord Speaker
cord
1 2,3
Т
В
Left speaker Right speaker
AM (MW) loop antenna
(supplied)
FM antenna
1
2
Connecting AM (MW) and FM Antennas
Place the antenna away from the unit and adjust its position
for the best reception.
1 Adjust the position for the FM antenna for
the best reception.
2 Connect the supplied AM (MW) loop
antenna to the AM LOOP terminal.
For better reception of both FM and AM (MW)
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM LOOP
FM ANTENNA
Do not connect the AC power cord until all other connections have been made.
06-08_UX-HB4[B]5.p65 04.7.27, 7:04 PM 7