JVC CA-UXHB4 - Manual (Page 23)

20
DISPLAY
Refreshing the Station List
For tuning in to the new available DAB stations, you need to
refresh the station list.
There are two ways for searching stations:
• Local search: Performs the search for stations on band III
in the United Kingdom.
• Full search: Performs the wider search for stations than
local search. When you bring this unit
outside of the United Kingdom, use this
search. This search is used mainly for the
use of outside of the United Kingdom.
For local search:
Press SCAN briefly.
For full search:
Press and hold SCAN for more than 2
seconds.
The search begins.
The number of found stations is counted as the search is
being proceeded.
When the progress bar reaches to the right side of the display,
the search finishes. After the search, the unit tunes in to the
previously tuned station.
To clear the stored memory, press RDS/INFO for
more than 2 seconds. Then, press SELECT after the
message appears on the display.
The DAB tuner starts the initial scanning.
SCAN
Number of the found stations Progress bar
Changing the Display Information
You can change the information appears on the display.
On the remote control ONLY:
Press DISPLAY.
• Each time you press the button, the information
changes as follows:
DLS (Dynamic Label Segment):
Text messages sent from the station
(Initial Setting)
Program Type: Types of broadcast programs
Ensemble: Type of ensemble
Time and Date: Time and day sent from the station
Channel and Frequency:
Channel number and transmission
frequency
Signal Information
Program Type
Sig.(Signal) Quality
Channel and Frequency
Ensemble
Time and Date
DLS
4
Press SEARCH/SCROLL UP
or SEARCH/SCROLL DOWN
to select a desired compression
level.
• Each time you press the button, the DRC
level changes as follows:
DRC 0: The DRC level adjustment is
canceled.
DRC 1/2: Medium level of compression is
applied.
DRC 1: Maximum level of compression is
applied. (Initial setting)
5
Press SELECT.
DRC 1 DRC 1/2
DRC 0
PRESET
GROUP
PRESET
GROUP
UP
DOWN
SEARCH/
SCROLL
DOWN
SEARCH/
SCROLL
UP
/
SELECT
Signal Information:
Digital bit rate (kbps) and signal mode
(stereo or mono)
Sig.(Signal) Quality:
Reception measurement sent from the
station (100 is the best reception)
• When the value is below 100, adjust
the position of the antenna for the
better reception.
PRESET
GROUP
PRESET
GROUP
UP
DOWN
SEARCH/
SCROLL DOWN
SEARCH/
SCROLL UP
/
SELECT
RDS/INFO
17-24_UX-HB4[B]6.p65 04.8.5, 6:17 PM 20