John Lewis JLDWW 1201 - Manual (Page 15)

15
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Close the dishwasher door
4. Press the On/Off button
The On/Off indicator light illuminates.
5. Setting and starting the programme
To select a programme, press the button of the
programme you wish to select, the indicator light of the
button illuminates and in the digital display will appear,
flashing, the running time of the programme that has been
set (in minutes).
The Programme time indicator light illuminates.
After about 3 seconds from the last pressure of a button
the programme starts automatically.
In the digital display the running time of the programme is
no longer flashing, the Programme time indicator light
remains illuminated.
Setting and starting the programme with
the delay start
The setting of the delay start occurs before
selecting the programme
Press the delay start button until the flashing number of
the hours for the delay start will appear in the digital
display (from 1h to 19h).
Select a washing programme. In the digital display will
appear, for a moment, the running time of the programme
and then again appears the selected delay start time.
As soon as the number of hours is displayed without
flashing, the countdown for the delay start is active.
The countdown will decrease with steps of 1 hour.
The opening of the door during the countdown will not
modify the delay start.
Once the delay start has elapsed the programme will
start automatically.
Note: With the delay start set, the Programme time
indicator light turns off. Once the countdown of the delay
start has elapsed, the washing programme will start
automatically and the Programme time indicator light will
illuminate.
Note: it is possible to select a washing programme and
the delay start also with the door slightly opened.
In this case the start of the programme or of the
countdown for the delay start will start automatically after
the closure of the door. Until this moment it is possible to
change or modify the setting made.
6. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in
progress ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is
opened. Open the door carefully.
To interrupt a washing programme in
progress
a) Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point at which it was interrupted.
b) Press the On/Off button, in this case all the indicator
lights turn off. Press the On/Off button again; the
programme will start from the point at which it was
interrupted.
To cancel a washing programme in progress
To cancel a washing programme you have to reset the
dishwasher; press simultaneously the function buttons 2
and 3 for about 2 seconds, the indicator light of the
running programme starts flashing for about 2 seconds.
After about 2 seconds all the indicator lights will turn off
(except for the On/Off indicator light and eventually the
rinse aid and salt indicator lights) indicating that the
running programme has been cancelled.
If a new washing programme will be selected, check that
there is detergent in the detergent dispenser.
7. To cancel a "delay start"
To cancel a delay start you have to reset the dishwasher;
follow the same instructions given in "To cancel a washing
programme". Cancelling a delay start involves also the
cancelling of the washing programme.
In this case you have to set the washing programme
again.
8. End of the washing programme
The dishwasher will automatically stop.
The Programme time indicator light turns off.
In the digital display appears 0 (remaining programme
time), only in this case the programme has ended.
If the door is not immediately opened at the end of the
programme, air will circulate inside the dishwasher to
prevent residual steam recondensing on the dishes as
water droplets.
This device operates intermittently for about 20
minutes, as long as the dishwasher is switched on.
If the On/Off button is pressed or the door is opened
during these 20 minutes, the device will be automatically
cancelled.
Switch off the dishwasher by pressing the On/Off button.
Open the dishwasher door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will
be cooler and the drying will be improved.
Starting a washing programme