Jensen JIMS-260I - Manual (Page 10)

GETTING STARTED
SPEAKER CONNECTION
Unpack the unit carefully. The speaker wires are already attached to main unit.
Handle with care to avoid damaging the wires.
Place the left speaker on the left side
of the main unit and place the right speaker on the right side of the main unit.
ANTENNA CONNECTION
FM: Untie and fully extend the FM Antenna wire for best reception.
POWER SUPPLY
This Music System operates on 120V AC~ 60Hz household power.
The remote control unit operates on one “CR2025” lithium battery (Included).
AC POWER CONNECTION
Connect the power cord to a 120V AC~ 60Hz power outlet.
Remarks:
In case of malfunction due to electrostatic discharge (ESD), reset the unit by
disconnecting and reconnecting the AC CORD to reset and to resume normal operation.
CONNECTING THE AC POWER
An AC-DC Adaptor with 10V DC 2000mA output (included) is required for
operating the main unit. Connect the AC-DC Adaptor to the unit and an AC outlet:
1.) Firmly and securely insert the DC plug of the adaptor into the DC Jack on the
unit
2.) Plug the Adaptor plug into a power outlet rated at 120V AC~ 60Hz.
Remote Control
The remote control operates on one CR2025 battery (included). To activate the
remote control, remove the insulation tab inserted in the battery compartment.
When the operation of the remote control becomes
intermittent or unsatisfactory, replace the original battery with
a new 3-volt lithium battery.
1.) Slide out the battery holder from the remote control case.
2.) Replace the 3V CR2025 battery. Be sure the battery is
installed correctly. The remote will not work if the battery is
installed with the wrong polarity.
CAUTION: Danger of explosion if the battery is replaced
incorrectly. Replace only with the same type
battery.
3.) Insert the battery holder back into the battery slot.
9