Jensen JIMS-260I - Manual (Page 12)

3.) To automatically search for stations with strong signals, press and hold either
the or button until the frequency read out on display begins to scan
then release the button. The tuner will stop on the first strong station signal it
finds.
4.) Adjust the sound level by pressing the VOLUME +
/
- buttons.
5.) Press the TIMER button to show the current time on the display. The time will
revert back to the station frequency readout after 5 seconds.
Notes:
•
Manual tune to select weaker stations that might be bypassed during
automatic tuning.
•
If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning
method to "fine tune" to the exact frequency of the desired station.
•
If a station is broadcasting in Stereo, the unit will automatically receive the
stereo broadcast.
Hints for the Best Reception
•
To obtain the best FM/FM Stereo reception, unwrap and fully extend the FM
Antenna and adjust the position of the wire for best station reception.
Setting the Radio Station Presets
The unit allows you to store up to
10 FM stations for easy recall at any time.
1.) In the FM mode, tune to the radio station you want to store in memory using
the or buttons.
2.) Press the MEM button. The preset channel number "P01" will be flashing on
display.
3.) To change the preset channel number location, press the MEM-UP or
MEM-DOWN buttons to step through the preset locations (P01 – P10)
.
4.) To confirm the preset location, press the MEM button.
5.) To store up to 10 FM station presets, repeat steps 1 to 4 above.
Note:
1. There is a 5 seconds delay when programming, after 5 seconds, the unit will
automatically switch back to normal tuner mode.
2. You can overwrite a present station by overwriting and storing the new
frequency in its place.
Recall Preset Radio Stations
1.) Set the unit to FM mode.
2.) Press the MEM-UP or MEM-DOWN button to select preset channel.
11