JVC DR-M10S - Manual (Page 102)

Filename [DR-M10SE_11Subsidiary.fm]
Masterpage:Left+
102
EN
Page 102 February 12, 2004 5:31 pm
SUBSIDIARY SETTINGS (cont.)
Set Stations (B)
Set station names other than the ones registered in your unit.
A
Select the character for station name.
A Press rt to select “ID”, then press ENTER.
B Press ENTER twice.
B
Enter the new character.
A Press w e to locate the character insertion point.
B Press rt to cycle through the characters (A–Z, 0–9,
–,
f
, +,
I
(space)) and stop when the desired
character is indicated, then press e to enter.
C Enter the remaining characters the same way
(maximum of 4).
D After entering all characters, press w e to select “OK”,
then press ENTER.
C
Close the Confirmation screen.
Press SET UP twice.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9, –
,
f , +, I (space) (maximum of 4).
Fine-Tuning Channels Already Stored
A
Select the channel to fine-tune.
A Press rt w e to select the channel you want to fine-
tune, then press ENTER.
B Press ENTER twice.
B
Access the Manual Channel Set screen.
Press ENTER. The Manual Channel Set screen appears.
C
Perform fine-tuning.
A Press rt to select “FINE”.
B Press w e until the picture appears in its best quality.
● Repeat steps A – C as necessary.
D
Close the Confirmation screen.
Press SET UP three times.
Perform steps A and B of “Manual Channel Set” on page 99
to access the Confirmation screen and then perform steps A
and B of “Set Stations (A)” ( ੬
pg. 101) before continuing.
Perform steps A and B of “Manual Channel Set” on page 99
to access the Confirmation screen before continuing.
DR-M10SE_01.book Page 102 Thursday, February 12, 2004 9:08 PM