JVC DR-M10S - Manual (Page 26)

Filename [DR-M10SE_06Name.fm]
Masterpage:Left0
26
EN
Page 26 February 12, 2004 4:33 pm
SAT CONTROL SET
Satellite Receiver
Control Setting
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the S
HOW V IEW timer
programming (
੬
pg. 54) or Manual Timer programming
(
੬
pg. 56) starts, the unit sets its input mode to “L-2” and
automatically switches the satellite receiver’s channels
using a provided Satellite Controller.
Installing Satellite Controller
A
Install a Satellite Controller.
Place a Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
B
Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
C
Make connections.
Be sure to connect the unit’s L-2 IN/DECODER connector
to the satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
D
Connect the Satellite Controller to unit.
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
Transmitter
21-pin SCART cable
(provided)
SAT CONTROL L-2 IN/DECODER
Your unit
Satellite Controller
(provided)
Satellite receiver
Back of unit
DR-M10SE_01.book Page 26 Thursday, February 12, 2004 9:08 PM