JVC LPT0762-001B - Manual (Page 12)

Filename [XVS20AG_06Index.fm]
Masterpage:Left0
12
EN
Page 12 April 9, 2003 5:08 pm
INSTALLING YOUR NEW UNIT
Basic Connections It’s essential that your unit be properly connected.
A
Check the contents.
Make sure the package contains all of the accessories
listed in “SPECIFICATIONS” on page 96.
B
Situate the unit.
Place the unit on a stable, horizontal surface.
C
Connect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8To connect to a TV with NO AV input connectors —
A Disconnect the TV aerial cable from the TV.
B Connect the TV aerial cable to the ANTENNA IN
connector on the rear panel of the unit.
C Connect the provided RF cable between the
ANTENNA OUT connector on the rear panel of the
unit and the TV’s aerial connector.
AV Connection
8To connect to a TV with AV input connectors —
A Connect the aerial, unit and TV as per “RF
Connection”.
B Connect the audio/video cable between the AUDIO/
VIDEO OUT connectors on the rear panel of the unit
and the TV’s audio/video input connectors.
D
Connect the unit to mains.
Plug the end of the mains power cord into a mains outlet.
Make AV connection if your TV has audio/video input
connectors in order to reduce the possibility of
interference. With AV connection, you can enjoy
stereo playback of video tapes if you are using a stereo
TV.
NOTES:
● For switching the TV’s mode, refer to the instruction
manual of your television.
● To obtain high-quality pictures, you can also use the
S-VIDEO connection and Component Video Connection.
(DVD deck only) (
੬
pg. 13, 14)
Aerial connector
Back of TV
Audio/video input
connectors
TV aerial
cable
RF cable
(provided)
Audio/video cable
(not provided)
Mains power cord
Mains outlet
Back of unit
AUDIO/VIDEO OUT
ANTENNA
IN
ANTENNA
OUT
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
After the connection is completed, perform “Video
Channel Set” on page 15.
XVS20AG_06Index.fm Page 12 Wednesday, April 9, 2003 5:08 PM