JVC LPT0762-001B - Manual (Page 31)

Masterpage:Right-No-Heading
EN
31
Filename [XVS20AG_07S-VHS.fm]
Page 31 April 10, 2003 9:57 am
G-
CODE
™/S
HOW
V
IEW
™ System Setup
The G- CODE timer programming system eliminates the need to input channel, date, start and stop time data when setting the timer
record function. Simply key in the G- CODE number for the TV programme you wish to record (found in most TV listings) and the unit’s
timer is automatically programmed.
You have to set Guide Program numbers, which are assigned to each station for purposes of S
HOW V IEW timer programming, for all the
stations stored in your unit’s memory to get proper results.
Before G-
CODE setup you must have performed Auto Set Up (
੬
pg. 16).
IMPORTANT
After setting the Guide Program Numbers, channel positions may be incorrect if you stored or skipped channels. In this case, re-
perform Guide Program Number setting.
Guide Program Number Set
A
Access the Main Menu screen.
Press SET UP MENU.
B
Access the Initial Set screen.
Press rt to move the highlight bar (pointer) to “INITIAL
SET”, then press OK or e.
C
Access the Guide Program Set screen.
Press rt to move the highlight bar (pointer) to
“G-CODE/SHOWVIEW SETUP”, then press OK or e.
D
Enter the Guide Program number.
Press rt or number keys to
enter the Guide Program
number for the desired station
as shown in the TV listings.
Then press OK or
e.
E
Enter the receiving channel position number.
Then press rt or number keys
to input the number of the
unit’s channel position on
which the Guide Program
number’s broadcast is received
by the unit. Then press OK or
e.
● If the satellite broadcast is
received on your unit’s auxiliary
channel “L-1”, select “L-1” for
the channel position.
● Repeat steps D and E as necessary.
F
Return to the normal screen.
Press SET UP MENU.
INFORMATION
G- CODE and S HOW V IEW are different trademarks used to represent the same easy recording feature, but only the term G- CODE
system will be used in the instructions. If you use the S HOW V IEW system, follow the same instructions listed for the G- CODE system.
Turn on the TV and select the video channel (or
AV mode).
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2 5
[0–9] OR [ / ] : SELECT
[MENU] : EXIT
(Example) When inputting the
Guide Program
number 2 for RTR.
Guide Program Number
“Guide Program (GUIDE PROG) number” refers to the
assigned TV station numbers, according to broadcast area,
for the G-
CODE timer recording. The Guide Program numbers
can be found in most TV listings.
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2 5
[0–9] OR [ / ] : SELECT
[MENU] : EXIT
(Example) If RTR is received on
channel position 2.
XVS20AG_07S-VHS.fm Page 31 Thursday, April 10, 2003 9:57 AM