Jabra FREEWAY - Manual (Page 5)

4
EN
G
LI
SH
JABRA FREEWAY
GETTING STARTED
You should follow three steps before using your speakerphone:
1 Charge your Speakerphone using the supplied USB cable and
car charger (approximately 2 hours)
2 Activate Bluetooth® on your phone or device (refer to the
manual of your device)
3 Pair your speakerphone to your phone or device
The first time you turn your Jabra FREEWAY on you will hear Voice
Guidance telling you what to do .
NOTE: Voice Guidance and Voice commands are enabled as the
default setting when you turn on your Jabra FREEWAY the first
time . You can at any time disable both by pressing the Voice
button while you slide the power switch into the On position .
You will hear ”Voice off” and FREEWAY will no longer talk to you
or listen for commands . Repeat the process to enable the voice
features again .
CHARGE YOUR SPEAKERPHONE
Make sure that your speakerphone is fully charged before you
start using it . Use the USB cable to connect Jabra FREEWAY to the
car charger . Plug the car charger into your car’s power outlet . The
charging indicator light will light up in red while charging . When
the Jabra FREEWAY is fully charged the indicator light will turn off .
A full charge takes approximately two hours .
Jabra FREEWAY can be charged outside your car using the USB
cable .