JVC DR-MV4SUJ - Manual (Page 58)

Filename [MV4S_09Advanced Operation.fm]
Masterpage:Left+
58
EN
ADVANCED RECORDING
Page 58Monday, 9 May 2005 09:39
Free Rate Function
To record the entire program, the unit automatically sets the
appropriate recording mode depending on the combination of the
total time of the program to be recorded and either the remaining
disc space or the specified recording time (from 60 minutes to 480
minutes).
8 To record the entire program within the actual remaining
disc space
Select “FR (JUST)” in a recording mode selection procedure.
● Note that this function is available only for timer programing recording
(
੬ pg. 31).
8 To record the entire program by specifying the desired
recording time
Select “FR60–FR360”, “FR420” or “FR480” in a recording mode
selection procedure. (
੬ pg. 28, 31)
8 To record a 25-min. long daily program five times just on
the same DVD disc for example
Perform “Manual Timer Programing” (
੬ pg. 31) procedure. Be
sure to set the recording mode to “FR125” and set Weekly/Daily
Rec Function to “MON–FRI” in step 9 to fit the total recording time
to the whole disc space.
When the same program is recorded in SP mode instead of in
“FR125”, the 5th program cannot be recorded.
NOTES:
● You can program this unit to timer-record, regardless of the disc
remaining time. When the disc remaining time is not enough,
recording may stop in the middle of a program. To avoid this, make
sure of the disc remaining time before setting timer programing.
(Example) If you programed to timer-record for 60 minutes in SP
mode on a 120-minute disc, the disc remaining time would be 30
minutes in XP mode, 60 minutes in SP mode, 120 minutes in LP
mode, 180 minutes in EP mode, and 240 minutes in FR480 mode.
Timer-recording will not complete beyond these remaining times.
● The maximum recording time of “FR (JUST)”mode is the same as the
recording time of FR480 mode. When timer programing a long
program in “FR (JUST)”mode on a disc whose remaining time is
short, it is recommended to check the disc remaining time in FR480
mode to see if the remaining time is enough for the program.
● Even if more than one program are timer programed in “FR (JUST)”
mode, only the first one is recorded.
● In order to ensure that the recording fits on the disc, this feature may
leave a slight non-recorded section at the end of the disc.
● There may be some noise and sound disturbance at the point on the
disc where the unit switches the mode.
Blank
A: 1st
B: 2nd
C: 3rd
D: 4th
E: 5th
A: 1st
B: 2nd
C: 3rd
D: 4th
E: Blank (20 min.)
Blank
Advanced Recording (VHS)
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Press VHS so that the VHS lamp lights up on the unit.
DISPLAY
CH +/–
TV INPUT
C.RESET
VHS
VHS/DVD
DVD VHS REC
VHS DVD DUBBING
CH STANDBY/ON
S-VIDEO VIDEO AUDIO
MV4S_09Advanced Operation.fm Page 58 Monday, May 9, 2005 9:39 AM