JVC LET0227-003A - Manual (Page 9)

Preparations
7
XV-C5SL/LET0227-003A/English
Pre
par
atio
ns
Vertical installation
Be sure to install the unit aligning the ∞ mark on the unit
and the 5 mark on the stand and be careful not to pinch
the cables.
Be sure to set the DIRECTION switch on the rear of the
unit to “2.”
NOTES
• Do not install the unit in the opposite direction without
aligning the marks. The unit is misaligned from the
stand.
• When you move the unit, be sure to hold not the stand
but the unit itself. If you hold the stand, the unit may
come off.
• Do not install the unit vertically without attaching the
stand. The unit may fall down.
Face-up installation
Be sure to install the unit aligning the ∞ mark on the unit
and the 5 mark on the stand and be careful not to pinch
the cables.
Be sure to set the DIRECTION switch on the rear of the
unit to “1.”
NOTES
• Do not install the unit in the opposite direction without
aligning the marks. The unit is misaligned from the
stand.
• When you move the unit, be sure to hold not the stand
but the unit itself. If you hold the stand, the unit may
come off.
• Do not install the unit with its face upward without
attaching the stand. The unit may fall down.
• Set the unit with the remote sensor faced toward you. If
the remote sensor is located on the opposite direction,
the remote control unit does not work.
Installation on the wall
Peel off the stickers on the bottom of the unit, hook the
unit onto the screws. Slide the unit downward to secure
it.
Be sure to set the DIRECTION switch on the rear of the
unit to “1.”
Mount two commercial screws onto the wall with each
screw located in the same height.
1 2
DIRECTION
1 2
DIRECTION
Remote sensor
CAUTIONS
• The unit weights approximately 1.7 k
g . When its
buttons are operated, an additional force will be
applied to it in the downward direction. Therefore,
sufficient care must be taken when attaching to a
wall to prevent any accidents caused by the unit's
falling off the wall.
• The screws needed for attachment are not supplied.
Use screws which are compatible with the strength
and material of the pillar or wall.
• Care is required in selecting a location for attaching
the unit to the wall injury to personnel, or damage to
the unit, may result if the unit is attached in a location
which interferes with daily activities or a location that
the users are liable to knock their bodies or heads
against.
• Avoid a location above a bed, sofa, water tank, sink,
etc. or in a passage.
• Do not hang from the unit or try to climb on the unit.
• If the unit falls down, disconnect the power cord at
once. Then, consult your dealer. Using the unit as is
may cause an electric shock or a fire.
178mm
4 to 5mm
10mm
4.2mm
1 2
DIRECTION
XV-C5SL(B).book Page 7 Friday, February 21, 2003 10:59 AM