Jensen Phase Linear SD1413 - Manual (Page 8)

SD1413
6
Preset Stations
Up to six stations on each band can be stored
as presets and can then be instantly recalled by
pressing the associated preset button on the
front panel (19-24) or remote control. To store a
station, turn the radio on and select the desired
band and station. Press and hold the desired
preset button (numbered one through six on the
face of the radio or remote control) for more
than two seconds. When stored, the preset
number will appear in the display. The station is
now stored and can be recalled at any time by
pressing the corresponding preset button.
Repeat for the remaining five presets on the
current band and for all presets on the other
three bands.
Preset Scan/Automatically Store
(PS/AS)
Automatically Store
Select six strong stations and store them for all
bands using the Automatic Store feature. To
enable this feature, press and hold the PS/AS
button (17) for more than two seconds. The
radio will automatically scan each band and
enter strong stations into the preset memory
positions. After entering the stations into
memory, the unit will automatically stop at each
station for five seconds so each can be heard.
When using the Automatically Store feature, the
new stations replace any stations already
stored in preset memory.
Preset Scan
Press the PS/AS button (17) to scan the six
preset stations in the AM band or all FM bands.
The unit will stop at each station for five
seconds before continuing to the next preset
station, and the preset number will flash on the
display during the preset scan. Press PS/AS
again to stop scanning and listen to the current
station.
SERIES
AF BUTTON(ALTERNATIVE FREQUENCIES)
When pressed short, AF
switching button (18)
mode is selected.
When AF switching mode is selected, the radio
check the signal strength of the AF all the time.
When pressed long, it is activated as regional
mode ON/OFF.
- Regional mode ON:
AF Switching or PI SEEK is implemented to the
station which have all PI codes are same as
current station. REG segment is turned on, in
LCD display.
- Regional mode OFF:
The Regional code in the format of PI code is
ignored when AF switching or PI SEEK is
implemented.
Some broadcasting stations may change their
program from normal broadcasting to regional
broadcasting for a certain period. When regional
mode is off, the region identification in the PI
code is ignored; the radio may switch to a local
variant of the current program. When region
mode is on, the radio will only switch to a
program carrying the exact same PI code.
TA BUTTON(TRAFFIC ANNOUNCEMENT)
When pressed short, it is activated as TA
mode on or off
When TA mode is on and traffic announcement
is transmittude
- When the unit is in CD mode, it will switch to
radio mode temporarily.
- If the volume lever was under the threshold
point, it will be raised to the threshold point.
- When TP station is received, TP segment is
turned on in LCD display.
When pressed long, EON TA LOCAL /EON TA
DISTANCE mode is selected.
- EON TA LOCAL mode
When the field strength level of EON linked is
less than the threshold level. The radio does not
switch that station and user can hardly listen to
any disturbances. “EON TA LO “ is displayed a
few second.
- EON TA DISTANCE mode
EON TA switching is try to implemented by the
information of current station “EON TA DX” is
displayed a few second this mode is selected
button
(25)
Note: When AF switch is on, at this moment
use tuning up/down to search station will only
stop at station which has RDS broadcasting.
Note: When TA switch is on, at this moment
use tuning up/down to search station will only
stop at station which has TA broadcasting.
PTY Button
Each time when this button is pressed, the PTY
PTY Music Group -> PTY Speech Group ->PTY Off
button(15)mode will toggle in the following order: